Calculated-industries 6020 v3.1 Manual do Utilizador descarregar pdf (Página 4)

2 – Scale Master

®

Classic

[MODE] – Mode Selection

Used to toggle between the following scale

modes (in sequence):

1) Architectural (

ARCH)

2) Engineering I (

ENG I)

3) Engineering II (

ENG II)

4) Custom (

CUSTOM)

5) Count (

COUNT)

[SUBTRACT/COUNT]+[MODE] –

Unit Selection

Holding

[SUBTRACT/COUNT] and

repeated presses of

[MODE] will scroll

through the available units. Values can be

converted from Imperial units to Metric

within the Imperial mode. However, values

cannot be converted from Metric to Imperial

when in Metric mode.

[SCALE] – Scale Selection

Used to toggle between various scales within

each scale mode. See “Built-In Scales” section.

[M1+] – Memory Add Key (Length)

Adds the displayed value to the M1+

memory. is key is used to store a length in

order to calculate an area.

[M2x] – Memory Add Key (Width)

Adds the displayed value to the M2x memory.

is key is used to store a width in order to

calculate an area. When a length and width have

been stored in

[M1+]

and

[M2x]

, pressing

[RCL] [M2x]

displays the stored width, the

next press of

[M2x]

displays the area calculated

from the stored length and width, and the next

press of

[M2x]

displays the calculated volume if

1 2 3 4 5 6 7 8 9 ... 39 40

Comentários a estes Manuais

Sem comentários