Calculated-industries 6020 v2.0 Manual do Utilizador descarregar pdf (Página 11)

ii. If you do not want to change the

unit of measure, go to step iii. To

change the unit of measure, press

[M1+] until you reach the desired

unit.

iii.Press [Scale] to advance through

the flashing digits until the display

returns to zero. The height is now

stored.

b. T

o Enter and Store a Height:

i. If you are entering a height (instead

of rolling), press [Subtract/Count]

and [M2x] simultaneously. The unit

of measure will begin flashing.

ii. If you do not want to change the

unit of measure, go to step iii. To

change the unit of measure, press

[M1+] until you reach the desired

unit.

iii.Press [Scale] to begin setting the

digits. The left-most digit will

begin flashing.

Press:

[M1+] to increment this digit

[Subtract/Count] to decrement

[Scale] to advance to next digit

[Mode] to move back one digit

iv. Continue pressing [Scale] until all

digits are set and the display returns

to zero. The height is now stored.

Note: Once you set your height, you do not need

to enter it again unless you want to change it.

11 – User’s Guide

6020UG-EFS-C 6/27/03 2:19 PM Page 11

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 43 44

Comentários a estes Manuais

Sem comentários