Calculated-industries 6130 v3.0 Manual do Utilizador descarregar pdf (Página 10)

“Rolling” a Measurement

To take a measurement with the Scale

Master II:

1) Switch the unit on. If the display

does not show zero (0), press the

[Reset] key to clear the display.

2) Select your type of scale by press-

ing the [Mode] key. Then press the

[Scale] key to select your scale.

3) Begin rolling. The display will reg-

ister your measurements. When

you roll the unit, be sure to hold the

unit upright (see picture 1 - next

page).

Also make sure you start and stop

at the exact points you are measur-

ing. Otherwise your roll may not

be accurate (see picture 2).

4) To store your measurement, press

the appropriate key (ex. [Length] to

label as length, [Width] to label as

width, etc).

5) Press [Reset] to reset the unit and

begin a new measurement.

10 – Scale Master

®

II v3.0

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 43 44

Comentários a estes Manuais

Sem comentários