Calculated-industries 6130 v2.0 Manual do Utilizador descarregar pdf (Página 5)

[Sub] is pressed simultaneously with

[Count], [+K] or [M+], the unit will

subtract the appropriate value.

[Count] – Count key

Used to increase the Count value by

one. Count is active in all modes.

Pressing [Reset] and [Count] simulta-

neously will clear the count.

[+K] – Constant key

Used to add a pre-set “constant”

value to the displayed measured

value. To set a constant value, you

press [Set] [+K] to place the unit in

programming mode.

[Rcl] – Recall key

Used to recall stored values. When

you press [Rcl] [Rcl], the last value

rolled is displayed.

[Mode] – Mode key

Used to cycle through the following

scale modes (in sequence):

1) Architectural (

ARCH);

2) Engineering 1 (ENG 1)

3) Engineering 2 (ENG 2);

4) Map (MAP);

5) Custom (CUSTOM).

User’s Guide – 5

1 2 3 4 5 6 7 8 9 10 ... 43 44

Comentários a estes Manuais

Sem comentários