Calculated-industries 4095-B User Guide Manual do Utilizador descarregar pdf (Página 12)

12 — PIPE TRADES PRO™

Pipeﬁtting Project Keys

Travel

Slope

Offset

Angleº

 Enters or calculates a linear Slope, Slope Angle,

or Percent Grade. The linear slope is the amount

of "Offset" over 12 inches of "Run." Values may be

entered as: 

● a Dimension:   

● an Angle or Degrees:   

● a Percentage (percent grade):      

Once an angle or slope has been entered, consec-

utive presses of  will convert to the remaining

formats listed above.

 Take-Out (T.O./Arc) – Used to enter or solve ﬁt-

ting Take-Outs when calculating pipe cut lengths.

Calculates inner, center, and outer arc lengths for

marking ﬁeld cut ﬁttings.

 Calculates or enters the Offset (Rise).

 Welder's Gap – Deﬁnes the Welder's Gap sub-

tracted from the end to end pipe length calculation.

Default value is 1/8", 0 is a valid value.

 Enters or calculates the Run.

 Enters or calculates the Travel (Diagonal).

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 67 68

Sem comentários

Calculated-industries 4095-B User Guide Manual do Utilizador Página 12