Calculated-industries 4094 User Guide Manual do Utilizador descarregar pdf (Página 11)

Us e r ’s GU i d e — 9

 (repeats options) Std.

Third press of  :

(Volume displays) VOL Std.

 VOL 0. CU FEET

 VOL 0. CU M

 (repeats options) VOL Std.

Fourth press of  :

(Meter Linear displays) METR 0.000 M

 (oating point) METR FLOAt M

 (repeats options) METR 0.000 M

Fifth press of  :

(Decimal Degree displays) DEG 0.00º

 (oating point) DEG FLOAt

 (repeats options) DEG 0.00º

Sixth press of  :

(Fractional mode) FRAC Std.

 FRAC COnSt.

 (repeats options) FRAC Std.

Seventh press of  :

(Mathematical Operation) MATH OrdEr

 MATH CHA1n

 (repeats options) MATH OrdEr

EnTERinG dimEnSionS

Linear Dimensions

When entering feet-inch values, enter dimensions from largest

to smallest — feet before inches, inches before fractions. Enter

fractions by entering the numerator (top number), pressing 

(Fraction Bar key) and then the denominator (bottom number).

Note: If a denominator is not entered, the fractional setting

value is used.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 43 44

Sem comentários

Calculated-industries 4094 User Guide Manual do Utilizador Página 11